عاوز اشغل تقرير من الفورم
انا عندى 10g
و بحثت فى المنتدى و كتبت الاكواد المكتوبة فى المنتدى و التقارير لاتعمل ايضا
و اخير اكتشفت انى لابد ان اشغل rwserver -install repserver

و لكن عندما اشغلة لايعمل ايضا

ارجو احد يساعدنى من البداية للنهاية لانى متوقف عند هذا الموضوع

اخى اليك هذة الطريقة التى عملها الأخ عمر باعقيل:

[You should create a new Reports Server Service for this example.

1) Create a simple report based on table EMP with a user parameter:

select * from emp where emp.deptno = :pdeptno;

2) Open up the Property Inspector of user parameter PDEPTNO and specify
the following:

Name: pdeptno
Datatype: Number
Width: 20
Initial value: 20 (It can be any valid value)

3) Compile and save the report. Try to run it using 'Run Paper Layout' icon
to make sure it works properly.

4) Create a simple form based on table DEPT:

select * from dept;

5) Create a new reports server service as following (in Command Prompt):

rwserver -install repserver90 autostart=yes

6) Open Property Palette for Reports object in the Forms Object Navigator
and enter the following:

Name:
EMP

Filename: C:\reports\emp.rdf
/*<specify full path to your RDF/REP file or make sure
this path is included into REPORTS_PATH environment variable*/

Report Destination Type:
CACHE
Report Destination Format:
HTML
Report Server:
repserver90

7) Open Layout Editor and create a push button 'Run-Report'.

8) Create a WHEN-BUTTON-PRESSED trigger with the following code:

test_report;

9) Create a new procedure that you can call from the trigger as follows:

PROCEDURE TEST_REPORT IS repid
REPORT_OBJECT; v_rep VARCHAR2(100);
rep_status VARCHAR2(20);
BEGIN
repid := find_report_object('report5');
SET_REPORT_OBJECT_PROPERTY(repid,REPORT_EXECUTION_MODE,BATCH); SET_REPORT_OBJECT_PROPERTY(repid,REPORT_COMM_MODE,SYNCHRONOUS);
SET_REPORT_OBJECT_PROPERTY(repid,REPORT_DESTYPE,CACHE);
SET_REPORT_OBJECT_PROPERTY(repid,REPORT_DESFORMAT,'html');
SET_REPORT_OBJECT_PROPERTY(repid,REPORT_SERVER,'repserver90'); SET_REPORT_OBJECT_PROPERTY(repid,REPORT_OTHER,'paramform=no pdeptno='||:dept.deptno);
v_rep := RUN_REPORT_OBJECT(repid);
rep_status := REPORT_OBJECT_STATUS(v_rep);
WHILE rep_status in ('RUNNING','OPENING_REPORT','ENQUEUED')
LOOP
rep_status := report_object_status(v_rep);
END LOOP;
IF rep_status = 'FINISHED' THEN /*Display report in the browser*/
WEB.SHOW_DOCUMENT('http://<YourServerName:8888/reports/rwservlet/getjobid'|| substr(v_rep,instr(v_rep,'_',-1)+1)||'?'||'server=repserver90','_blank');
ELSE
message('Error when running report');
END IF;
END;


10) Compile the form.

11) Run the form,
populate the record.

12) Click on the push button.
]